You need to have some knowledge of what to look for and expect from doing your own plumbing. You need to know what resources are available to you and who can provide you answers as to what you need for your future plumbing jobs. The tips below can help you with how to start.
Solder with safety in mind. When you solder a copper pipe you want to direct the flame on the copper pipe. The flame of the torch has to be four inches away from the piping. The flame should be targeted directly at the point where the copper piping needs to be disconnected.
To help you find a good plumber, you should get recommendations from people whom you trust. Asking a friend or a neighbor is usually more trustworthy than picking a random plumber out of the phone book. You need a competent plumber, otherwise you could be in for a much bigger problem down the road.
Use a hairdryer to thaw frozen pipes, after you shut off the water to the house. A hairdryer will gently heat the pipe and thaw the ice without causing significant damage to the pipe. Shutting off the water first means that if the pipe is broken, there will be no rush of water into the house.
Check your gas water heater periodically to make sure the pilot flame is lit. The correct color for this flame should be blue. The tip of the flame should be yellow. If you find that you are only seeing a yellow flame, you may need to call a professional for safety reasons.
As you have seen in the above tips, there is a lot of knowledge you can acquire before starting to do your own plumbing and it’s this knowledge that can help you with your future plumbing jobs. Do everything you must to find out what you need to get started.